Use and Care Guide
ASSEMBLY INSTRUCTIONS
10
2
3
1
1. Mount the auxiliary handle (B) into the drill by
sliding auxiliary handle over front of drill until it
slides against bracket on drill housing. Once in
place, turn handle clockwise until it is horizontal
with grip handle. Turn handle grip (B) clockwise
until it is completely tight (See Figure 1).
2. Remove the air inlet protective cap from the
air inlet (G) (See Figure 2).
3. Mount a male plug (not included) by hand into
the air inlet (G) (See Figure 3).
NOTE Use threaded sealant tape (not included)
on the threading of the male plug. Once sealant
tape is properly in place, tighten male plug turning
clockwise with a wrench (not included) for air tight
connection. DO NOT OVERTIGHTEN.