Use and Care Guide

ASSEMBLY INSTRUCTIONS

IMPORTANT: The battery pack is not charged

the rst time, place the battery pack in the battery

charger and charge.

when it is purchased. Before using the blower for

• Align the battery (C) with the cavity in the handle

housing on the blower (A).

• Grasp the trigger handle (H) rmly.

• Insert the battery in the opening until the battery

release button (G) locks into place. You should

hear a “click” once it is installed.

• Press the battery release button (G). This will

cause the battery to raise out of the tool.

• Grasp the trigger handle (H) rmly. Pull the battery

pack out of the handle.

Note: The battery ts into the handle snugly in or-

der to prevent accidental dislodging. It may require

a strong pull to remove it.

a. To install the battery:

b. To remove the battery:

WARNING

Follow these instructions in order to avoid injury and to reduce the risk of electric shock or re:

• Replace the battery pack or the charger immediately if the battery case or charger cord is damaged.

• Verify that the switch is in the OFF position before inserting or removing the battery pack.

• Verify that the battery pack is removed and the switch is in the OFF position before inspecting,

adjusting, or performing maintenance on any part of the blower.

• Read, understand, and follow the instructions contained in the charger manual.

BATTERY