Use and Care Guide

ADJUSTMENT INSTRUCTIONS

9. Bevel-Angle Indicator Adjustment

a. Remove the battery pack from the tool.

b. Square the blade to the table to make sure that

the blade is 90° to the table.

c. Rotate the bevel-lock knob to lock the bevel.

d. Check to see if the bevel-angle indicator (G) is

pointing to 0° on the bevel scale (H).

e. If the indicator is not pointing to 0°, loosen the

bevel-angle indicator screw, adjust the indicator

to 0° on bevel scale and then retighten the

screw.

10. Adjusting the Blade to the Miter Table 45°

Bevel, 0° Miter

a. Remove the battery pack from the tool.

b. Loosen the bevel-lock knob (AA) to release the

bevel. Move the left sliding fence (U) all the way

out along the horizontal direction.

c. Pull the 45° stop block (X) toward the rear of the

saw.

d. Tilt the saw head to set the bevel-angle to 45°.

NOTE: To obtain correct bevel angles, rotate the

bevel-stop lever (I) to the other side to pull it out, and

tilt the saw head to the desired angle.

e. Place a combination square (not included) on

the miter table with the rule against the table and

the heel of the square against the saw blade (O).

NOTE: Be sure to rest the square against the body of the blade, and not against the teeth of

the blade.

f. If the blade is not 45° to the miter table, adjust by tightening or loosening the bevel-stop

bolt (Z) on the tool with a 6mm hex key (not included).

g. Retighten the bevel-lock knob and push the bevel-stop pin in. Recheck the blade-to-table

alignment.

screw

Z X Y