Use and Care Guide

ADJUSTMENT INSTRUCTIONS

The miter saw is properly set and adjusted prior to shipping. The adjustments were made at

the factory and normally do not require re-adjustment.

If, in the course of use, adjustments are required, please follow the directions below.

WARNING

• Battery tools are always in operating condition. Therefore, always remove the battery pack

from the tool before making any adjustments or installing accessories, failure to do could

result in accidental starting causing serious injury.

6. Squaring the Blade to the Fence

a. Remove the battery pack from the tool.

b. Lower the saw arm all the way and engage

the arm-lock pin (AC) to hold the saw arm in

“DOWN” position.

c. Set the bevel and miter angles to 0°.

d. Place the heel of a combination square (not

included) against the blade (O) and the rule of

the square against the xed fence (T).

NOTE: Be sure to rest the square against the body

of the blade, and not against the teeth of the blade.

e. If the blade is not 90° to the fence, adjustments

are needed。

f. Lift the miter-control lever (P) to unlock the miter

table (L).

g. Hold the miter-control lever to rotate the miter

table until the miter-angle indicator (N) is at

approximately left 30° position on the miter

scale (M).

h. Loosen the three screws that hold the miter

scale in place.

i. Lift the miter-control lever to rotate the miter

table to the 0° position on the miter scale or

until the detent engages in the miter-scale

detent plate.

j. Adjust the miter angle until the blade is ush

with the square.

k. Press the miter-control lever down to lock the

turn table.

l. Tighten the two visible screws that secure the miter scale.

m. Lift the miter-control lever to rotate the miter table until the pointer is at approximately left

30° position on the miter scale.

n. Tighten the remaining screw to secure the miter scale detent plate.

NOTE: If the saw has not been used recently, verify that the blade is square to the fence, and

readjust if necessary.

combination

square