Use and Care Guide

OPERATING INSTRUCTIONS

1. To Attach Battery Pack

a. Align the raised portion on the battery pack

with the grooves on the bottom of the tool,

then slide the battery pack onto the tool, as

shown.

b. Make sure that the battery-release buttons

on the battery pack snap into place and the

battery pack is secured to the tool before

beginning operation.

NOTICE: When placing the battery pack on the

tool, be sure that the raised rib on the battery pack

aligns with the groove on the tool and the latches

snap into place properly. Improper assembly of the

battery pack can cause damage to internal components.

To Detach Battery Pack

a. Press the battery-release buttons to release the battery pack.

b. Pull forward on the battery pack to remove it from the tool.

WARNING

• Battery tools are always in operating condition. Therefore, always turn off the light when the

light is not in use or when carrying the tool at your side.

2. ON/OFF Switch

a. To turn the work light ON, press the ON/OFF

switch (D). The work light will be turned on at

maximum brightness.

b. To reduce the brightness, press the ON/OFF

switch again.

c. To turn it OFF, press the ON/OFF switch a third

time.

WARNING

• Do not continue to press the ON/OFF switch

after the work light has automatically switched

off. The battery can be damaged.

• When the battery charge is low, the work light

will cycle from maximum brightness to lower brightness, back to maximum brightness, and

then turn off. Charge the battery to avoid battery damage.

Battery-Release

Buttons