Operating Guide

kobalttools.com
13
ASSEMBLY INSTRUCTIONS
WARNING
• If any parts are damaged or missing, do not operate this product until the parts are replaced. Using
a product with damaged or missing parts could result in serious personal injury.
• Do not attempt to modify this product or create accessories not recommended for use with this
'>
leading to possible serious personal injury.
• Do not insert the battery until assembly is complete and you are ready to mow. Failure to comply
could result in accidental starting and possible serious personal injury.
• To prevent accidental starting that could cause serious personal injury, always remove the battery
pack from the product when assembling parts.
• Never operate the mower without the proper safety devices in place and working. Never operate
the mower with damaged safety devices. Operation of this product with damaged or missing parts
could result in serious personal injury.
1a. Assembling the handle
Raise the lower handles (O) and lock into place
by turning the handle lock knobs (P) to the locked
position. Ensure the bolt slides through the handle
bar bracket on both sides of the mower.
Note: Make sure that both handles are in the same
notch on the handle bar bracket. If not, the upper
handles will not assemble properly.
1a
1b
O
P
G
AA
BB
O
1b. Align the upper handle (G) with the lower
handle (O) on both sides. Slide the handle
bolts (AA) through the holes in the handles
and tighten with the handle knobs (BB) on both
sides. If the connection is not stiff, hand tighten
the handle knobs.
Note: Do not overtighten the handle knobs.
Unlocked
position
Locked
position