Parts List

OPERATING INSTRUCTIONS

14. Tuning AM and FM

a. Press the mode button (M) several times until the AM or FM is shown on the display (F). A

radio station can be tuned to manually or automatically (scan-tuning).

b. Manual tuning: Briey press the ‘<<’ button (L) or ‘>>’ button (J) to reach the desired

frequency. Each press will increase or decrease the frequency by 0.1MHz for FM and

10kHz for AM range. The frequency is shown on the display.

c. Automatic/Scan Tuning: Press the ‘<<’ button (L) or ‘>>’ button (J) and hold for 2 seconds,

the tuner will automatically seek the rst radio station with strong signal and stop at that

station’s frequency. The frequency is shown on the display. The ‘>>’ button (J) may be

pressed for 2 seconds again to continue seeking more radio stations at higher frequencies.

The ‘<<’ button (L) may be pressed to seek radio stations at lower frequencies.

15. Storing Stations in Preset Memories

(AM and FM)

There are 5 memory presets for each waveband.

a. To store the current radio station, press and

hold the preset button (K) until the preset

number is shown on the display, then press the

‘<<’ button (L) or ‘>>’ button (J) to select the

preset number, from ‘Preset 1’ to ‘Preset 5’,

you wish to save the station under.

b. Briey press the preset button (K), the preset

number will ash on the display once and then

stay on, and the station is stored successfully.

Stations stored in the preset memory can be

overwritten by following the same steps.

c. To recall stations from the preset memories,

briey press the preset button (K) while the unit is in AM/FM mode. The preset number and

station frequency will appear on the display. Press the preset button (K) repeatedly until

the desired preset station is on the display.

87.50

MHz

KL J