Operating Guide

6
SAFETY INFORMATION
POWER SOURCE REQUIREMENTS
The power source must be able to supply the necessary current to operate the load. The Kobalt 80V
battery is the only DC power source to be used with this product.
WARNING
Keep ventilation when using batteries.
Power Inverter should only be used with 80V Kobalt battery pack.
CONNECTION TO LOAD
The inverter is equipped with a AC power receptacle. Plug the cord from the equipment you wish to
operate into an AC receptacle. The green LED indicator lights to indicate that the inverter is functioning.
Make sure the combined load requirement of your equipment does not exceed inverter’s output rating.
The inverter is engineered to be connected directly to standard electrical and electronic equipment in
the manner described above.
Do not connect the power inverter to household or RV AC distribution wiring.
Do not connect the power inverter to any AC load circuit in which the neutral conductor is connected to
ground (earth) or to the negative of the DC (battery) source.
OPERATING ENVIRONMENT
For best operating results, the inverter should be placed on at surface, such as the ground, car oor,
or other solid surface. The inverter should only be used in locations that meet the following criteria:
DRY
- Do not allow water and/or other liquids to come into contact with the power inverter.
COOL
– Do not place the inverter on or near a heating vent or any piece of equipment which is
generating heat above room temperature. Keep the inverter away from direct sunlight, if at all possible.
SAFE
– Do not use the inverter near ammable materials or in any locations that may accumulate
ammable fumes of gases.