Use and Care Guide

OPERATING INSTRUCTIONS

4. Operating with the Screwgun

NOTICE: We recommend using a standard, long

bit (approximately 150mm length x 5mm shank

diameter) when operating the screwgun with the

collated attachment.

Install the screwgun bit:

a. Remove the battery from tool.

b. Pull the stop sleeve to remove it from the tool.

c. With one hand, push the bit sleeve back and

hold it in place.

d. With the other hand, insert the long screwgun

bit (J) into the hexagonal hole in the bit

retainer.

e. Release the bit sleeve and check that it returns

to its original position.

Install the collated attachment to the screwgun

a. Align the bit with the hole on the collated

attachment.

b. Push the collated attachment until it snaps into

place.

NOTE: The bit is magnetized and will hold most

commercial drywall screws.

Operating the screwgun with the collated

attachment

a. Install the screw strip.

b. Adjust the depth stop (A), set the screw length,

and adjust the screw-in depth.

c. Set direction of rotation (clockwise) on the

screwgun.

d. Grip the tool with both hands on the handle and

assume a working position.

e. Place the depth stop against the workpiece to

be screwed in place. Hold the tool at right angle

to the workpiece surface.

f. Turn on the screwgun. The screw is screwed

into the workpiece until the set screw-in depth

is reached. The bit will automatically stop

rotating.

g. When you have nished driving screws, switch

off the screwgun.

Stop sleeve

Bit sleeve