Use and Care Guide

15
CARE AND MAINTENANCE
All maintenance should only be carried out by a qualied service technician.
Care of Accessory
Accessory should be stored in an organized way so can be removed without disturbing or
damaging other accessories with their safety information.
Store in a place that is cool and dry, away from direct sunlight and excess heat or cold.
Cleaning
Before cleaning or performing any maintenance, remove the battery pack from the tool.
For safe and proper operation, always keep the tool and its ventilation slots clean.
Always use only a soft, dry cloth to clean your screwgun; never use detergent or alcohol.
TROUBLESHOOTING
WARNING
• Make sure that the slide switch (D) is in the “OFF” position and detach the battery pack from
the tool before performing troubleshooting procedures.
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
The tool does not
work.
Low battery capacity. Charge the battery pack.
Battery overheating.
Release the switch, wait for the
battery to cool down, then start
the tool again.
Wheels cannot be
installed.
Wrong size. Replace wheels with correct size.
Motor overheating. Cooling vents are obstructed.
Clean and clear vents. Do not
cover vents with hand during
operation.