Operating Guide

kobalttools.com
30
CARE AND MAINTENANCE
Side plate angle
• Correct 80° – Produced automatically if you use the

• Hook – “Grabs” and dulls quickly; increases the


• Backward Slope – Needs too much feed pressure;
causes excessive wear to the bar and chain. Results

too high.
Side plate angle
• Maintain the depth gauge at a clearance of 1/32 in.
(0,79 mm). Use a depth gauge tool for checking the
depth gauge clearances.
 
clearance.
Depth Gauge Jointer

Raker (Depth Gauge) Clearance
1/32”
(0,79 mm)
Hook
Incorrect
Backward Slope
 
gauges uniformly. Use a 1/32 in. (0,79 mm) depth
gauge jointer.