Use and Care Guide

ASSEMBLY INSTRUCTIONS
Hardware Used
EE
x 2
x 4
x 4
x 4
Wall strap
BB
#8-32 x 3/8 in. Bolt
CC
#8-32 Nut
DD
ST4 x 20 mm
Screw
9. Screw one end of wall strap (EE) to
the top back panel (A) with
#8-32 x 3/8 in. bolts (BB) and #8-32
nuts (CC). Secure the other end to the
wall with ST4 x 20 mm screws (DD).
Repeat for another wall strap (EE).
10. OPTIONAL
Hardware Used
x 2 x 2
HH
ST4.8 x 100 mm Pan
head screws
II
5 x 15 x 1.2 mm
Washer
A
10
II
HH
To install the unit to the wall without a
K-Rail
®
, follow the below step.
Otherwise proceed to optional K-Rail
®
mounting instructions on the next page.
Move the unit to the wall, making sure
the back of the unit is flush with the
wall. Feed the ST4.8 x 100 mm pan
head screws (HH) through the 5 x 15 x
1.2 mm washers (II) and top back panel
(A). Screw the ST4.8 x 100 mm pan
head screws into wall studs, and
tighten securely.
Note: Screws must be placed into wall studs.
The unit will not be secured if screwed into
drywall. If there is a gap between the unit and
the wall due to moulding on the garage floor,
please make the unit press against the
moulding and be parallel to the wall.
9
Lowes.com
Wall
Note: This cabinet should be anchored to the
wall using the wall strap (EE) to avoid any
potential danger from cabinet falling. Check
and see if the top (D) is level. If not level due to
uneven floor, the two doors will probably not be
properly aligned. In this case, use an
adjustable wrench (not included) to adjust the
hex nut until the top (D) is level.
EE
A
D
9
DD
BB
CC
EE
Wall