Use and Care Manual

®
®
KB200 Maintenance and Cleaning Procedure
CLEANING PROCEDURE
MAINTENANCE PROCEDURE
Koalabear.com
MAY 2017
Koala Kare Products A Division of Bobrick 6982 South Quentin St., Centennial, CO 80112-3945 Main 303.539.8300 Toll Free 888.733.3456 Fax [phone]
465-XX-KIT ............Liner Dispenser
466-XX-KIT
...................... Liner Lid
472-KIT
...............................Shock
473
.................... Instructional Label
476-KIT
................... Installation Kit
481-KIT
.....................Bungee Cord
492-KIT
.................................. Key
495
...........................Exterior Label
885-KIT
................................ Strap
975
................... Warning Label- US
KB150-99
..................... Bed Liners
KB200 Replacement Parts
1
1
2
2
3
3
4
4
5
1. Prepare Area
Put on gloves. Place wet oor sign
outside restroom/facility door.
1. Clean Exterior
Apply detergent with a spray bottle/ pre-moist-
ened towel/rag or brush to BCS exterior. Allow
to sit (dwell) for 30 seconds, and then clean
exterior with the nylon brush. Remove detergent
with a dry (microber) rag. Apply disinfectant
(with a spray bottle/pre-moistened towel/ rag or
brush) on BCS exterior and allow to air dry.
2. Inspect Baby Changing Station (BCS)
Examine BCS exterior for dirt or soil.
2. Clean Interior
Open BCS. Unlock liner dispenser, remove bed
liners and set aside. Apply detergent (with a spray
bottle/premoistened towel/rag or brush) to BCS
bed surface, straps, and lower portion of the back
wall. Allow to sit (dwell) for 30 seconds, then
clean the bed, straps and back wall area with a
nylon brush. Remove detergent with a dry (micro-
ber) rag. Apply disinfectant (with a spray bottle/
pre-moistened towel/rag or brush) on the BCS
bed, straps and back wall and allow to air dry.
3. Inspect Door
Open and close BCS door. Shock may need
replacement if door opens too rapidly or door
doesn’t close. If the door does not close once it is
lifted to roughly 40º or if the door falls open with-
out slowing, then the shock needs to be replaced.
3. Replace Bed Liners
Replace/ll the bed liners behind elastic cord.
Lock liner dispenser. Close the BCS, and apply
the disinfectant (with a spray bottle/pre-moist-
enedtowel/ rag or brush) on the handle area
again. Inspect exterior to ensure no visible soil or
damage. (Inspect wall/oor below unit to ensure it
is free of soil or liquids.)
4. Inspect Strap and Buckle
With door open, inspect strap for wear and tear.
Ensure buckle opens smoothly and closes with
a “click”. If belt is caught in the hinge portion of
BCS, unscrew, x and reattach making sure the
strap works properly. Replace if necessary.
4. Wash Cleaning Supplies
Return cleaning equipment and wet oor sign to
the custodial closet. Wash nylon brush and allow
to air dry. Wash/ replace (microber) rag and or
towel when soiled. Replenish detergent and disin-
fectant containers. Check inventory of bed liners
(and alert Supervisor toreorder if inventory is low.)
5. Warning Label
Inspect warning label. Replace if missing or
damaged. Close the BCS.