Quick Start Guide for NB-IoT Wireless Data Terminal KDC Series Version：V1.0 Release Date：2018.5.9 文档版本 V1.0 （2018.3.
Operation Frequency: TX LTE Band 2: 1850MHz-1910MHz TX LTE Band 4: 1710MHz-1755MHz TX LTE Band 5: 824MHz-849MHz TX LTE Band 12: 699MHz-716MHz TX LTE Band 13: 777MHz-787MHz TX LTE Band 17: 704MHz -716MHz TX LTE Band 25: 1850MHz-1915MHz TX LTE Band 26 : 814MHz-849MHz TX LTE Band 41: 2496MHz ~2690MHz TX LTE Band 66: 1710MHz-1780MHz RX LTE Band 2: 1930MHz-1990MHz RX LTE Band 4: 2110MHz-2155MHz RX LTE Band 5: 869MHz-894MHz RX LTE Band 12: 729MHz-746MHz RX LTE Band 13: 746MHz-756MHz RX LTE Band 17: 734MHz -746MHz
(1)§ 15.19 Labelling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. § 15.21 Changes or modification warning Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. § 15.
Quick Start Guide for NB-IoT Wireless Data Terminal --KDC Series step 1: use the needle to insert the hole of sim card slot, then pup out sim card tray and pull out sim card tray. step 2: put the data card on the sim card tray correctly and insert them into sim card slot horizontally. step 3: upturn the chip of data card and insert it into NB terminal. step 4: connect the antenna to NB terminal and tighten clockwise to fix it on the NB terminal.
Quick Start Guide for NB-IoT Wireless Data Terminal --KDC Series Step 7: click “ ” button. Step 8: click “ Step 9: click “ V1.0 （2018.5.9） ”, check “ ” on the pop-up window. ”button. Knowyou Technologies Co.,Ltd.
Quick Start Guide for NB-IoT Wireless Data Terminal --KDC Series Step 10: find Port （ COM and LPT) on the Device Manager of laptop and select “ ”. Step 11: find Modem on the Device Manager of laptop and select the last modem on the drop-down list of Modem, such as “ ” shown in the following picture. V1.0 （2018.5.9） Knowyou Technologies Co.,Ltd.
Quick Start Guide for NB-IoT Wireless Data Terminal --KDC Series Step 12: click the drop-down list on the right side of Modem/Net port under the Mobile(ETC) on the Port Setting window and select “ ”. Step 13: click the drop-down list on the right side of AT port under the Mobile(ETC) on the Port Setting window and select “ V1.0 （2018.5.9） ”. Knowyou Technologies Co.,Ltd.
Quick Start Guide for NB-IoT Wireless Data Terminal --KDC Series Step 14: click the drop-down list on the right side of ADB port under the Mobile(ETC) on the Port Setting window and select “ ”. Step 15: it indicates NB network was connected successfully when the “ ” icon in the bottom-left corner of OP Terminator window appeared. V1.0 （2018.5.9） Knowyou Technologies Co.,Ltd.
Quick Start Guide for NB-IoT Wireless Data Terminal --KDC Series V1.0 （2018.5.9） Knowyou Technologies Co.,Ltd.
