User's Manual

Using The Pedometer

Press MODE until you see the pedometer display. The default

setting for this mode is OFF. (Fig. K)

NOTE: Before using the pedometer for the first time you must

adjust the sensitivity to accurately check your stride.

See

Calibrating your Pedometer

(Page 13.)

To turn the pedometer ON, press and hold MODE button for

3 seconds and OFF will begin to flash.

Press SCROLL UP and DOWN to cycle between pedometer ON &

OFF.

Press SELECT to confirm choice; you will hear a beep.

If the pedometer mode is set to ON Steps and Distance screens

will be displayed:

Press MODE until you see the steps taken display. (Fig. L)

Press SCROLL UP or DOWN to reset to 0.

Press MODE again to show the distance walked display. (Fig. M)

To change readout from miles to kilometers, press and hold

MODE for 3 seconds. Then PRESS SCROLL UP or DOWN to switch

between miles and kilometers and press SELECT to lock in.

PRESS SCROLL UP or DOWN to reset to 0.

Fig. K

Fig. L

Fig. M