User Guide
Knoll Ofce Tables
© Knoll, Inc.
Digital Control Switch
Quick Set-Up Guide
Program a Quick Sit Height
1. Move the table to seated height.
2. Press and hold for 3 seconds.
3. Immediately press . Quick sit is programmed.
4. To travel to the Quick Sit Height, press and hold .
Program Quick Stand Height
1. Move the table to standing height.
2. Press and hold for 3 seconds.
3. Immediately press . Quick stand is programmed.
4. To travel to the Quick Sit Stand, press and hold .
Program Positions 3, 4 or 5
1. Move the table to desired height for position 3.
2. Press once and immediately press once.
3. The Menu mode icon will appear in the top left corner.
4. Press until the display reads 3.
5. Press to store position.
The display will conrm the setting by ashing three times.
Repeat steps above for positions 4 and 5, navigating to
Presents 4 and 5 respectively.
To Travel to Stored Positions 3, 4 or 5
1. Press once. The memory icon will appear in the top
left corner.
2. Use to navigate to stored positions 3, 4 or 5.
3. Press and hold while the table moves to the stored
position.
Operating the Table
Tone and Antenna Telescope feature press-and-hold
adjustments to prevent injury to users and damage to
surrounding objects. To adjust the table up or down or to
move to any of the preset heights, a user must press and hold
the appropriate button.
For Use with Tone and Antenna Telescope
The Antenna Digital Control Switch is designed for use with Tone Height-Adjustable Tables
and Antenna Telescope. The switch features basic up and down buttons; programmable
quick sit and quick stand buttons; and three additional programmable height settings.
This document will guide users through basic set up and programming the most
commonly-used functions of this Switch. For more detailed instructions, or for the full
Antenna Digital Control Switch User Guide, visit the Tone or Telescope product pages at
www.knoll.com.