user manual

10
We recommend the T568A wiring method, which is shown below.
The functions of each wire connection are also shown.
future use brown
future use white/brown
Infrared orange
ground white/blue
+12 vdc blue
future use white/orange
SDA green
SCL white/green
Run CAT5 wire from the keypad location to the CI6 location for each keypad or run it
from keypad to keypad location. Ideally home runs are used as they leave the
installation more “future proof” and reliable. Leave an extra 1 m or 3 feet on each
side to make it easier to work on. Add a RJ45 connector of the right type for the
CAT5 wire you have selected (not all CAT5 wires are the same) and crimp the
connector to the wire on each side. Plug the RJ45’s into the MR164 and correct CI6
ports.
Note: MR164 keypad installer programming, see MR164
programming near the end of this manual.
Infrared connections
On the rear of the CI6 there are seven infrared pass though ports. Each of the 1
through 6 corresponds to the keypad port next to them. For example IR port #3 is
the infrared output for keypads connected to KEYPAD #3. The infrared ALL is the
combination of all of the 6-keypad ports.
Using this method of infrared routing you can have six sources the same (like 6
identical AM/FM tuners) one for each zone and they can be controlled individually in
each room. Each port can control up to 8 devices using 4 of our optional IR34a
emitters and one IR55 connection block.
Each infrared port is a standard 3.5mm mono jack.
DATA IN and DATA OUT connections
On the rear of the CI6 amplifier there are two 3.5mm stereo jacks labeled DATA IN
and DATA OUT. These ports connect two or more CI6’s together so they can share
infrared commands and ALL commands (such as All Off)
When connecting two CI6’s together in one system you will need:
1. Up to fourteen (one for each active source) RCA patch cords
2. A 3.5mm stereo patch cord.
We do not recommend using “Y” adaptors in this case. Normally the two CI6’s are
near each other. If they are far apart then balancing baluns may be required to
eliminate stray noise on the lines.