User's Manual

39
Recall Memory: Select Memory from the General menu, and then press Enter to activate Recall Memory.
Use the
or buttons to select the modes: User-1, User-2 or Default.
Save Settings: Select Memory from the General menu, and then press
to highlight Save Settings.
Use the
or buttons to select the modes: User-1 or User-2.
Figure 4-7: Memory Sub-Menu
Blank Screen: Select Blank Screen from the GENERAL menu to choose the color of the blank screen that appears
when no source signal is present. The options are Logo, Black, Blue and White. The default is Black.
Logo Display: Select to enable or disable the splash screen.
Auto Source: This function scans for active sources when the current source is not available (default setting is Off).
bration, measurement and fault isolation purposes. To access them, select Test Patterns from the GENERAL menu
and set it to On. The available test patterns are:
White
Black
Red
Green
Blue
Cyan
Magenta
Yellow
ANSI Checkerboard
Horizontal Gray Ramp
Focus Grid
Press
or on the remote control unit or built-in keypad to cycle through the test patterns.
Note
The OSD menus are not available when in “test pattern” mode.
To turn test patterns off, press any key other than
or on the remote control unit or built-in keypad.
Blue Only: This feature removes all red and green color information from the image, and is useful for color-calibrat-
ing the projector or other video components.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
operaTion
Test Patterns: The LED1081 has numerous internal test patterns that are useful to technicians for advanced cali-