User's Manual

30
insTallaTion
Connecting an External IR Receiver
If infrared signals from the remote control cannot reach the projector due to excessive distance or obstructions such as
walls or cabinet doors, you can connect an external IR repeater system to the IR INPUT on the LED1081 to extend the
range of the remote control. See Figure 3-12. iKontrol compatible! See www.ikontrol.biz for more information.
IR INPUT VIDEO
S-VIDEO
COMPONENT 1 - SCART
(3.5-mm, mini
phono plug)
Knoll IR Sensor
Knoll IR Repeater
Remote Control
Figure 3-12: External IR Receiver Connection
Connecting to AC Power
The LED1081 ships with North American type of AC power cord. source one that is appropriate to your AC standard.
Plug the female end of the power cord into the AC receptacle on the rear of the projector (AC 100V ~ 240V); see
Figure 2-3. Then, connect the other end to your AC power source.