User's Manual

Power RS232

S-Video HDMI

VGA

Rear Connector Panel

USB

12 VDC triggers

Composite video Component video Wired remote

The projector provides the following connection options:

• VGA computer.

• Two HDMI™ (High Definition Multimedia Interface)

• Three Component Video (RCA)

• S-video

• Composite video (RCA)

• USB port

The projector also provides the following connectors:

• RS-232 for serial control

• 12-volt DC output (see below)

Three 12-volt DC outputs

The 3.5mm mini-jack trigger provides a 12-volt, 0.25 amp DC output. It provides a constant output

while the projector is on. It has numerous uses. For example, if you connect your projection

screen to the 12-volt DC output with the cable that came with your screen, when you turn on the

projector the screen will move down; when you turn the projector off, the screen will return to the

storage position.

12V+

ground

3.5mm plug 12VDC output

screen relay (see screen

manufacturer for details)

The “Lamp” trigger turns on when the lamp is lighted. If you connect your projection screen to this

output using the cable that came with your screen, the screen will move down when the lamp is

turned on and the screen will return to its storage position, when the lamp is turned off.

The Letterbox “1” and “2” triggers are active when the projector is placed in letterbox mode and

are utilized for variable masking and anamorphic lens control. (These triggers are off when

SplitScreen is active.)