User's Manual

Function Command Response

Brightness (BRT10) Sets brightness to 10

Power (PWR0) Turns power off

Power (PWR1) Turns power on

Error Conditions

Not all commands are supported for all projectors. If an unsupported command is issued, the

command will be ignored. If a command is received that is not understood, a „?‟ character will be

returned indicating the command was not understood.

Limitations

The projector cannot respond to commands coming in at a high-rate. Therefore, a delay must

occur between commands to ensure that the command gets properly executed. To assure the

projector can process a command, wait 3 seconds before entering the next command.

The Step column refers to increasing or decreasing the menu bar position since the On-screen

Display is not an exact match of values. For example, Step 2 changes the data by 2 through the

CLI (Command Line Interface). The menu bar is up (or down) by 1.