User's Manual

13
The LCD display then displays:
Source 2
Press the UP or DOWN buttons next to the INPUT buttons again to scroll through the label
selections for source 2 on the bottom row of the LCD display. When the correct selection is
displayed press the INPUT button to confirm this choice.
Continue programming for sources 3, 4, 5, 6 and 7 in the same manner. The keypad labels have
been set. To change any of the labels you can re-enter the installer menu and scroll through all
seven labels and reset the ones needed.
3. Equalization (if required). The LCD display then displays
BASS
Press the UP or DOWN buttons next to the INPUT buttons to set the bass level. When the correct
level is displayed press the INPUT button to confirm this choice.
The LCD display then displays
TREBLE
Press the UP or DOWN buttons next to the INPUT buttons to set the treble level. When the
correct level is displayed press the INPUT button to confirm this choice.
System
Off
Adjusting the Keypad Backlighting
MR164’s are backlit for easy nighttime operation. To adjust the backlighting make
sure the power for the keypad is on and the MR164 is off (not playing any sources).
The LCD display then displays
System
Off
Without pressing any other buttons press the UP or
DOWN button to increase or decrease the
backlighting illumination. The level selected will
remain in the memory even if the power is
disconnected.
RB12 Remote control functions.
Knoll Systems service information
The CI6 amplifier does not contain any user serviceable
parts inside. If you suspect a problem that may require
servicing, contact us at
MUTE ALL
1 2 3 4
5 6 7
SELECT SO URCE
Mute
Button
Volume
up and down
buttons
Direct
access
select
source
buttons
ALL button for whole
house functions
Shut off this room
or shut off whole
house (press for
5 seconds
RB12
VOL