Datasheet
Cable Shears
with twin cutting edge
95
1
>
for cutting copper and aluminium cables
>
not suitable for steel wire and hard drawn copper conductors
>
precision ground, hardened blades
>
clean and smooth cut without crushing and deformation
>
by dividing the cutting actions into initial cut (insulating sheath in the
front cutting area) and final cut (conductor in the back cutting area),
cables up to Ø 20 mm can be cut in onehand operation
>
less effort required due to favourable lever ratio and optimised cutting
edge geometry
>
guard prevents operators‘ fingers being pinched
>
adjustable bolted joint, selfretaining screw
>
Highgrade special tool steel, forged, oilhardened
Initial cut: using the front cutting edge to cut the insulating sheath on larger cable diameters leaves
an ergonomic handle opening width
Final cut: after cutting the sheath in the front profile the conductors in the rear part are cut Initial
cut in the front profile, final cut in the rear profile – to keep it as easy as possible
Cutting capacities
Article No
EAN
003773
mm Tool Handles Ø mm mm² AWG g
95 11 200 03928 200
burnished plastic coated 20 70 2/0 283
95 12 200 0783 200
burnished with multicomponent grips
20 70 2/0 32
95 16 200 026761 200
chrome plated
insulated with multicomponent grips,
VDEtested
20 70 2/0 30
95 17 200 026952 200
chrome plated handles with dipped insulation, VDEtested
20 70 2/0 360
The twin cutting edge allows a comfortable handle position in all
cutting situations within the specified cutting capacity.
95 11 200
95 12 200
95 16 200
95 17 200
155
CABLE AND WIRE ROPE SHEARS