Instruction Manual

•
•
•
•
•
•
•
•
•
•
•
•
•
•
INSTALLATION
Note - If this product is being used in conjunction with an external PIR or sensor, please
confirm with the manufacturer of the sensors that they are compatible with LED luminaires.
• Provide power to the required point of installation (refer to BS7671 for correct cabling
methods). Suitable IP rated junction boxes should be used where required
• Remove the diffuser by unfastening the three screws on the front
• Open the hinged LED plate by releasing the tab labelled “OPEN” (see Fig. 1)
• Drill the fixing holes in the rear of the fitting. Mark the location of the fixing holes and drill
ensuring not to infringe with any gas/water pipes or electrical cables
• Feed the mains cable through the rubber grommet to retain IP rating, or alternatively, drill
out one of the two 20mm drilling guides on the sides of the fitting (see Fig. 2)
Fig. 1