INSTALLATION & MAINTENANCE MANUAL SHE1BEMS / SHE1GEMS SHE2BEMS / SHE2GEMS
GENERAL INSTRUCTIONS These instructions should be read carefully and retained after installation by the end user for future reference and maintenance. These instructions should be used to aid installation of the following products: SHE1BEMS / SHE1GEMS / SHE2BEMS / SHE2GEMS SAFETY • This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671) and current Building Regulations.
• • • • • • • • • Connect the luminaire to the mains supply ensuring the correct polarity is observed (see Fig. 1): L - Live (brown),• E - Earth (green/yellow), N - Neutral (blue). The earth terminal is non-functional and only provided for convenience Fig. 1 • Ensure the earth lead on the LED plate is secured correctly to the earth lead on the body of the fitting • Fix the LED tray to the body • Choose •the required colour temperature by means of the three-position switch (see Fig. 2) • • Fig.
• SENSOR DIP SWITCH LAYOUT DIP SWITCH SETTINGS
WARNING This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance testing. Irreparable damage will occur if this instruction is not followed. This product is not suitable for installation in or near a coastal or marine environment.
GENERAL This product contains a light source of energy efficiency class D to Regulation (EU) No. 2019/2015. This product contains a non-replaceable LED light source and a control gear which can be replaced by a professional. Clean the external surfaces with a damp cloth using a mild solution of detergent and warm water only, do not use aggressive cleaning products or solvents which may damage the product. This product is non-dimmable.
TESTING FOR EMERGENCY LUMINAIRES Recommended routine test procedure in accordance with BS5266 • • Daily check – check LED charge indicator is illuminated Monthly functional test - simulate a mains supply failure for approx. 30 seconds by operation of key switch or switching off circuit breaker.
SUPPLIED BY: (UK) MANUFACTURER ML ACCESSORIES LTD, UNIT E CHILTERN PARK, BOSCOMBE ROAD, DUNSTABLE LU5 4LT, WWW.MLACCESSORIES.CO.UK (EU) AUTHORISED REPRESENTATIVE SLV LIGHTING GROUP, DAIMLERSTRASSE 21-23, 52531 ÜBACH-PALENBERG, GERMANY EMAIL: EPREL@GROUP.SLV.
Manufacturers Declaration of Conformity For ML Accessories (Knightsbridge) Electrical products in accordance with CE marking ML Accessories Ltd.
Manufacturers Declaration of Conformity For ML Accessories (Knightsbridge) Electrical products in accordance with UKCA marking ML Accessories Ltd. declare that all products have been designed, manufactured, and tested in accordance with the requirements of the relevant legislation UKCA marking legislation UK SI 2016 No. 1091 UK SI 2016 No. 1101 UK SI 2012 No. 3032 UK SI 2017 No. 1206 UK SI 2021 No.
