Installation Guide
•
•
•
•
• Feed the cable through the compression gland on the rear of the access plate. A drip loop
should be left on the incoming mains cable (see Fig. 2)
• Connect the luminaire to the mains supply ensuring the correct polarity is observed:
L - Live (brown), E - Earth (green/yellow), N - Neutral (blue) (see Fig. 3)
• Replace the access plate and screws ensuring gasket is in place then tighten the
compression gland ensuring a tight seal to maintain the IP rating
• Fix the bracket to the surface using suitable screws
• Switch on and check for correct operation
Fig. 2
•
•
•
•
Fig. 3