Installation Guide
FLPxxxx
•
•
•
•
•
•
•
•
•
•
•
Remove screws
INSTALLATION
Note - If this luminaire is being used in conjunction with an external PIR or sensor, please
confirm with the manufacturer of the sensors that they are compatible with LED luminaires.
• Provide power to the required point of installation (refer to BS7671 for correct cabling
methods). Suitable IP rated junction boxes should be used where required
• Round cable should be used for the mains supply. The use of flat cable will cause water
ingress to the fitting
• Using the bracket as a template, mark the location for, and drill the fixing holes ensuring
not to infringe with any gas/water pipes or electrical cables
• Remove the four screws on the access plate at the rear of the fitting to expose
the terminal block (see Fig. 1)
Fig. 1