INSTALLATION & MAINTENANCE MANUAL FLPxx
GENERAL INSTRUCTIONS These instructions should be read carefully and retained after installation by the end user for future reference and maintenance. These instructions should be used to aid installation of the following products: FLP100 / FLP100A / FLP150 / FLP150A / FLP200 / FLP200A SAFETY • This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671) and current Building Regulations.
FLPxxxx INSTALLATION Note • - If this luminaire is being used in conjunction with an external PIR or sensor, please confirm with the manufacturer of the sensors that they are compatible with LED luminaires. • • •Provide power to the required point of installation (refer to BS7671 for correct cabling •methods). Suitable IP rated junction boxes should be used where required • ••Round cable should be used for the mains supply.
• Feed the cable through the compression gland on the rear of the access plate. A drip loop should be left on the incoming mains cable (see Fig. 2) Fig. 2 • Connect the luminaire to the mains supply ensuring the correct polarity is observed: • L - Live (brown), E - Earth (green/yellow), N - Neutral (blue) (see Fig. 3) • Fig.
WARNING This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance testing. Irreparable damage will occur if this instruction is not followed. This product is not suitable for installation in or near a coastal or marine environment. GENERAL • The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire should be replaced.
WARRANTY This product has a warranty of 3 years from date of purchase. Failure to install this product in accordance with the current edition of the IEE Wiring Regulations (BS7671), improper use, or removal of the batch code will invalidate the warranty. If this product should fail within its warranty period, it should be returned to the place of purchase for a free of charge replacement. ML Accessories does not accept responsibility for any installation costs associated with the replacement product.
