INSTALLATION & MAINTENANCE MANUAL FL8ABK / FL8AW / FL16ABK / FL16AW
GENERAL INSTRUCTIONS These instructions should be read carefully and retained after installation by the end user for future reference and maintenance. These instructions should be used to aid installation of the following products: FL8ABK / FL8AW / FL16ABK / FL16AW SAFETY • This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671) and current Building Regulations.
• Fig. 1 • Mark the location of the fixing holes and drill the holes ensuring not to infringe with any gas/water pipes or electrical cables • • Feed the mains cable through the rubber grommet to retain IP rating, and secure the baseplate to the • • Connect the luminaire to the mains supply ensuring the correct polarity is observed: L - Live (brown), N - surface Neutral (blue). The earth terminal is non-functional and only provided for convenience (see Fig. 2) • Fig.
Fig. 3 • See below for sensor settings • Switch on and check for correct operation • • SENSOR SETTINGS An initial verification of the detection area can be carried out by turning the TIME dial to the TEST setting (see Fig. 4). In test mode the sensor is initially activated for approximately 1 minute, then for three seconds every time motion is detected. Fig.
Once the detection area is verified, the sensor duration can be set via the TIME dial - from a minimum of 10 seconds to a maximum of 15 minutes. The lux setting can be adjusted via the LUX dial - from a minimum of 5 lux (indicated by the moon icon) to daylight (indicated by the sun icon). When set to daylight, the sensor will activate when movement is detected regardless of the ambient light level. The field of detection can be adjusted left or right by rotating the ring around the PIR (see Fig. 5).
Specific zones within the detection area can be blocked if required by using the blanking inserts provided (see Fig. 6). Each section of blanking insert covers a zone of a 300° angle. Fig. 6 WARNING This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance testing. Irreparable damage will occur if this instruction is not followed.
GENERAL This product contains a light source of energy efficiency class F to Regulation (EU) No. 2019/2015 and (UK) 2021 No. 1095. This product contains a non-replaceable LED light source and a non-replaceable control gear. Clean the external surfaces with a damp cloth using a mild solution of detergent and warm water only, do not use aggressive cleaning products or solvents which may damage the product. Do not use any source of high-pressure washers to maintain or clean this luminaire.
(UK) MANUFACTURER ML ACCESSORIES LTD, UNIT E CHILTERN PARK, BOSCOMBE ROAD, DUNSTABLE LU5 4LT, WWW.MLACCESSORIES.CO.UK (EU) AUTHORISED REPRESENTATIVE SLV LIGHTING GROUP, DAIMLERSTRASSE 21-23, 52531 ÜBACH-PALENBERG, GERMANY EMAIL: EPREL@GROUP.SLV.COM MADE IN CHINA >80 40°C CRI TA 85 ML Accessories Limited LU5 4LT www.mlaccessories.co.
