Instruction Manual

• Mark the location of the ﬁxing holes and drill the holes ensuring not to infringe with any

gas/water pipes or electrical cables

• Feed the mains cable through the rubber grommet to retain IP rating, and secure the

baseplate to the surface

• Connect the luminaire to the mains supply ensuring the correct polarity is observed (see

Fig. 3): L – Live (brown), E – Earth (green/yellow), N – Neutral (blue). The earth terminal

is non-functional and only provided for convenience. The additional L’ – Slave live is able

to power additional luminaires. A maximum of 400W LED load can be controlled by the

sensor

Fig. 3

• Refasten the LED plate screw

• Reattach the diffuser by rotating clockwise

• Switch on and check for correct operation