Phau Ntawv Qhia

•

INSTALLATION

• Provide power to the required point of installation

• The driver can be ﬁxed to a solid surface (if required) by using the ﬁxing points shown

below

• Unscrew the terminal cover screws (see Fig. 1) and remove the terminal covers

• Connect the driver to the mains supply ensuring the correct polarity is observed: L - Live

(brown), N - Neutral (blue)

• Connect a suitable LED load to the secondary side of the driver: + (red) - (black)

• Reﬁt the two terminal covers ensuring the outer sheath of each cable is secured under

the cable clamp

• Switch on and check for correct operation

Fig. 1