Manual

3� Remove the forearm stock� By using the screwdriver end of the combo tool, take out
the stock screw (S9) located on the underside of the stock� The stock and barrel easily
separate�
4� Remove the barrel� Using the socket end of the combo tool, take out the bolt (S6)
that is located in the forearm stock chamber� Unscrew it counter clockwise, until it
slides out of the receiver� Pull the barrel up and out to release it from the receiver�
Assembly
1� Install the breech plug� Fill the threads of the plug with Knight Breech Plug Grease to
help prevent the breach plug from sticking in the receiver� Using the breech plug end
of the combo tool, insert the breech plug (I) into the rear of the receiver and hand-
tighten the plug into the receiver until it is firmly against the back of the barrel� Be
sure the breech plug is screwed all the way into the receiver� Do not over tighten the
plug or it will become difficult to remove�
2� Install the trigger assembly�
3� Install the barrel and stock� Replace the stock screw (S9) and bolt (S6�)�
Knight Rolling Block (KRB7)
46