Manual

Knight Rolling Block (KRB7)

Trigger Blocking Cross Bolt Safety

This safety mechanism blocks the movement of the trigger to the rear (fire) position� This

safety bolt consists of a red plastic ring embedded in the bolt to indicate the position of

the safety� When the red ring is visible, the safety is off and when the trigger is pulled the

hammer will fall and a loaded gun will fire�

WARNING

The trigger blocking cross bolt safety prevents firing of the rifle from

the cocked position only. Do not allow the hammer to rest on the firing pin with the

hammer spur safety in the up (fire) position when the rifle is primed! An accidental

discharge can occur from impact to the hammer or dropping the rifle even with the

trigger safety engaged. Never transport, carry, or handle your rifle in this condition.

Fire

Safe

Disassembly and Assembly

WARNING

Be sure the muzzleloader is not loaded or primed before disassembly or

assembly.

Study the rifle schematic and acquaint yourself with the different parts and terminology

of your muzzleloader before assembling or disassembling� Letters and numbers in paren-

theses refer to labels on each rifle schematic for each model�

It is advisable to use a padded vise to remove and reinstall the breech plug� Place small

parts in a pan to avoid losing them�

Disassembly

1� Remove the trigger assembly� Press the release button located just behind the trigger

guard� Swing the action away from the rifle and pull it out of the receiver�

2� Remove the breech plug� Insert the combo tool (socket end first) into the receiver,

engage the plug (I) and turn it counterclockwise until it slides out of the receiver� This

may require more force� (A hole in the combo tool allows for the use of a rod, for

added leverage�) Put the plug in a jar of Knight solvent for a few minutes while clean-

ing the barrel and receiver�