Manual

5� To assemble, thread the striker assembly clockwise into the bolt body� Do not apply

any pressure after the threading reaches the end� Do not tighten the striker against the

bolt housing�

6� When the striker assembly reaches the end of the threads, turn it counterclockwise,

until reference points (Photo #3 - Letters D and E) are aligned with each other� Hold

your thumb against the bolt (Photo #4 - Letter E) (this will help allow you to keep

the bolt body and bolt striker assembly aligned correctly) then unscrew the secondary

safety until there is no more pressure� If the assembly is not aligned, repeat steps 2, 3,

5, and 6�

7� While pulling out on the spring-loaded Quick Release bolt screw (Photo #1 - Letter

A), slide the bolt all the way back into the receiver� Release the bolt screw� Make sure

the trigger and secondary safeties are both in the safe position� Close the bolt handle�

8� The rifle is now in the cocked position with both safeties on�

209 Conversion Non-Full Plastic Jacket Breech Plugs

The DISC Extreme and Long Range Hunter can be converted to use 209 primers with-

out the DISC Full Plastic Jacket�

1� Remove old breech plug from rifle�

2� Generously grease new breech plug with breech plug grease�

3� Insert new breech plug utilizing existing combo tool�

4� Place enclosed adaptor in bolt body as shown in figure below:

Mfg# 900044

DISC Extreme™ .45/.50/.52 and Long Range Hunter