Manual

31
Action and Safety Systems
Bolt Action
The bolt has been designed for easy removal and breakdown for easy cleaning of internal
and external surfaces� The rifle also features a removable breech plug, making it easier
to clean the bore thoroughly from one end to the other� The design also allows you to
unload the rifle without firing by pushing unfired powder and/or bullet out the back of
the barrel with the ramrod�
Bolt Assembly
Bolt Handle
Secondary Safety
Bolt Body
Cocking Piece
Full Plastic
Jacket
The bolt functions by lifting the handle and pulling back slightly to expose the priming
port at the face of the bolt� This also cocks the hammer� To prime the rifle with a 209
primer, press the primer flush into the Full Plastic Jacket™ (DISC)� Insert the Full Plastic
Jacket into the receiver� When the bolt handle is pushed forward and down, it is formed
over the primer and nipple� Full Plastic Jackets are not designed for reuse�
Patented Double Safety System
The trigger safety is located on the right side of the trigger� When the safety is pulled
to the rear, it is in the safe position� This locks the trigger so that the hammer will not
release� When the safety is pushed forward, it is in the fire position and the hammer will
release if the trigger is pulled�
The secondary safety is located on the rear of the hammer or bolt� This safety is activated
by turning the secondary safety in a clockwise motion� The use and design of the sec-
ondary safety is to keep the rifle from firing by not permitting the hammer to strike the
igniter� When the safety is turned in a counter-clockwise motion until it stops, it is in the
fire position� Both safeties must be in the fire position to fire the rifle�
DISC Extreme™ .45/.50/.52 and Long Range Hunter