Manual

22
Disassembly and Assembly (Muzzleloader)
Trigger and Firing Pin Removal
1. Turning the receiver and butt stock slightly on its side locate the trigger group release
lever (as shown in photo #9). While gripping the trigger group, push the release lever
forward and hold. With a slight rocking motion, remove the trigger group by pulling
out and away from the receiver (as shown in photo #10). Set the trigger group aside.
Photo #9 Photo #10
2. Turn the receiver upside down and locate the firing pin retainer set screw (as shown in
photo #11). Using the flat screwdriver end of the extractor, turn the firing pin retainer
set screw approximately two turns clockwise. Turn the receiver upward, and with your
free hand catch the firing pin, as it will freely fall from the receiver. Set it aside.
Photo #11
3. Do not disassemble your rifle any further. Any additional disassembly should only be
performed by a qualified gunsmith or by Knight Rifles warranty staff.
Assembly
Firing Pin And Trigger Assembly
1. Replace the firing pin in the firing pin retaining hole located in the hammer slot of
the receiver. Ensure that the firing pin is rotated to enter the bottom firing pin hole.
Turn the receiver upside down and locate the firing pin retainer set screw (as shown in
photo #12). Using the flat screwdriver end of the extractor turn the firing pin retainer