Manual

Disassembly and Assembly (Muzzleloader)

7. While holding the receiver and butt stock with the action open and the breech

exposed. Grip the Full Plastic Jacket (FPJ) extractor with the thumb and index finger,

remove the extractor by pulling straight back (as shown in photo #5). When using the

Bare 209 breech plug, there will not be a FPJ extractor required.

Photo #5

8. Insert the combo tool (socket end first) into the breech and engage the breech plug

(as shown in photo #6). Turn it clockwise until it slides out freely (see photo #6). This

may require more force (a hole in the combo tool allows for the use of a rod for added

leverage). Set breech plug aside.

Photo #6

9. Turn the rifle slightly to its side, and by using the flat head of the extractor push the

pivot pin through the receiver and weld lug until the barrel is free (as shown in photos

#7 and #8). It is important that you balance the barrel and receiver to prevent the bar-

rel from dropping or falling out of your hands. Set the barrel, pivot pin and extractor

aside.

Photo #7 Photo #8