Installation Instructions

ManualsBrandsKnape & Vogt ManualsBarn Door HardwareMetro 48" Long Wall Mount Clear Etched Aluminum Barn Door Hardware Kit

FASTENING RECOMMENDATIONS

ATTACH WALL-MOUNT TRACK

• Track is designed to be secured on 16" centers or less (to line up with wood or steel framing structures) and within 8" of each end. For walls with

greater spacing between structural members, additional structure must be provided to achieve the required fastener spacing.

• Layout the location of the track on the wall. The door-closed side of the track should overlap the nished opening by 5/8" for a 1/2" door overlay.

Adjust the track overlap greater or lesser to achieve the desired door overlay. The track fastener mounting line is placed level at a height 3-1/4"

above the nished header.

• Find the locations of the structural wall framing members or solid anchor points and transfer to the track. If the mounting locations do not meet

the requirements above, additional structure must be provided to achieve the required fastener spacing.

NOTE: The track must be level in order for door to stay level.

• A shim board may be required to space track from wall to clear base or door molding and to provide a at surface to mount track.

• Drill clearance holes for mounting fasteners using a 13/64" bit through track at the transferred locations. Locate hole centers on the groove

provided in the track mounting surface.

• Secure the track to the wall through the pre-drilled holes into the structural wall members using fasteners per section 1.

• Place hangers in wall track.

• Track mounting fasteners are not supplied due to

differences in wall construction type and codes. Choose

track mounting fasteners appropriate for the structure.

Fasteners and the structural members they are attached

to must be capable of 75 lbs. shear and tension to

support the maximum rated load. Follow local building

codes for load-bearing items secured to the wall

type. Local code supersedes any of the following

recommendations.

WOOD FRAMING:

• Use #10 Type A or Type AB thread pan head or hex-washer head.

Choose a length of screw so that 1” minimum is engaged into the

supporting wall structural member.

STEEL FRAMING:

• Use #10 Type AB thread pan head or hex-washer head. Screw length

must allow a minimum of three threads to protrude beyond inner wall

of framing.

MASONRY WALLS:

• Use appropriate anchors for the wall material. Anchors and substrate

must be able to support 75 lbs. minimum shear and tension loads.

SLIDING DOOR HARDWARE - WALL-MOUNT

Assembly

Instructions

#310374_A (0913)

A Wall construction shown is for reference only

B 16.0" fastener spacing maximum

C 8.0" max. unsecured either end

D Horizontal track position relative to stud locations is determined by opening

location on wall and trim thickness. Position shown is for reference only.

E Recommendation: Finished opening height = Door height + 3/8"

F Recommendation: Finished opening width = Door width - 1"

G Finished oor

H Door height

I May need to remove quarter round or shoe if large enough to interfere

with door operation

J 3/8” ± 3/16” if > 9/16”, must shim 1915 oor guide up to meet spacing.

K Finish oor

L Finish wall

M Shim to match spacing of casing molding

N Rough header

O Finish header

P 1/16" nominal to hide hardware from opp. side. If needed, add 3/8" x 1-1/4"

stop to nish header to hide hardware in lower position.

Q 3/8" x 1-1/4" stop (not included /not required)

R Door casing

3-1/4"

5/8"

7/16"

1/4"

3-3/16"± 3/8"

3/8" Ref.

3-1/4"

1-3/4"

1-3/8"