Installation Guide

Grand Rapids, MI
800.253.1561
simplyputorganizers.com
©2018 Knape & Vogt. All rights reserved. Knape & Vogt
®
reserves the right to change specifications without notice. 310673/1018
Push the slide back so that the
mounting hole is accessible.
Install 1 – #6 x 1/2" wood
screw (4).
Ensure that upright brackets
are parallel to the front of the
cabinet then attach to the base
of the cabinet with 4 – #8 x 3/4"
wood screws (5A).
NOTE: Screws can be placed
in slotted holes for future
adjustment or in round holes to
ensure the unit does not move.
Push rear slide brackets back
until they are against the back
of the cabinet. Attach to the
back of the cabinet with 3 –
#6 x 1/2" wood screws
per bracket (5B).
Fully extend slides. Install
lower rack to left hand slides
by placing tabs through the
wire rack. Next push rack into
hooks on right hand slides while
supporting the slide member.
Repeat process for upper rack (6).
Using 1-#6-32x5/16" screw
install cross-brace to left-hand
side of front upright bracket
directly below upper basket
slides. Repeat process for
right –hand side of front
upright bracket.
Snap cookware dividers into
place on the lower rack where
desired.
Attach support bar to lower rack
crosswise between cookware
dividers where desired.
4
5A
5B
6
Left Slide Right Slide
6
8
5
4
5B
5A
7
8A
8B
7
8B
8A