Installation Guide

Step 1 To locate the unit inside your cabinet, place a shelf
on the post and position it inside the cabinet so
the door can close without interference. Mark all
screw hole locations on the cabinet floor. Remove
the post and shelf from the cabinet. Drill pilot
holes for fastening screws, and attach the post to
the cabinet floor using the screws provided.
Step 2 Assemble the shaft collars by placing
T-nuts through holes and inserting
setscrew into T-nut. Turn screw 2 or 3
times to engage. It will be tightened
later. Place one of the shaft collars
(slotted side up) at the desired height for
the lower shelf and tighten setscrews
finger-tight to hold in place. Position the
shelf with the pie-cut in the front and
rotate the shaft collar to fit the shelf
hub. Tighten the setscrew on the collar
and close the door to check for
clearance.
Step 3 Place the remaining shaft collar(s)
(slotted side up) on the post and repeat
the installation instructions above. Insert
the top mount support in the top of the
post. Lift the top mount support up
towards the top of the cabinet and
secure it in place using screws
and washers provided.
Installation is now complete.


Installation Instructions
RN269EFS_B_WireLzySusn_0213
© 2013 Knape & Vogt Manufacturing Company. All rights reserved.
Inspect all parts and read all instructions prior to beginning assembly and installation.
Parts Included
A. (2 or 3) Shelves
B. Post
C. (2 or 3) Shaft collars
D. (4 or 6) setscrews
E. (4 or 6) T-nuts
F. Top mount support
G. Mounting screws

• Phillips head Screwdriver
• Drill with 1/16” (1.5mm) bit for drilling
pilot holes
• Pencil

PC24STM
PC28STM
PC32STM
A
B
C
D
E
F
step 1
step 2
step 3

F

KNAPE & VOGT MANUFACTURING COMPANY
2700 Oak Industrial Drive NE • Grand Rapids, MI 49505
800.253.1561 • www.kv.com