Installation Sheet
Insert one dowel into each hole (). Place
Mounting Board Back on top of Mounting Board
Bottom. Insert screw into mounting hole (
).
Tighten with Phillips head screwdriver.
Place sliding base assembly on cabinet floor,
right behind the back edge of the cabinet face
frame. If installing in a frameless cabinet,
measure 1/2" to 3/4" back from front of cabinet
opening, and align sliding base assembly
parallel to cabinet opening. Close door to
make sure the assembly will not hold cabinet
door open. Also, check to see if unit will clear
the door opening when fully extended. Once
position is determined, fasten in place using
four mounting screws (E) provided and the
Phillips head screwdriver.
OPTIONAL: Mark placement of mounting holes
with a pencil, remove sliding base assembly
and drill pilot holes for fastening screws. Place
sliding base assembly back into position and
fasten with the provided screws (E).
Fit tray dividers onto mounting board. Product
assembly TDRO6 is supplied with 2 dividers,
TDRO9 is supplied with 3 dividers.
Slide mounting board with tray dividers attached
into the installed sliding base assembly, by
inserting the wheels on mounting board into
the tracks on the sliding base assembly. The
mounting board should move freely along the
track. Installation is now complete.
Parts Included
A. Tray Divider (not assembled to board)
B. Mounting Board Bottom
C. Mounting Board Back
D. Sliding Base Assembly
E. Mounting Screw Package
F. Hardware Pack
(one screw, two dowels)
Tools Required
• Phillips Screwdriver
• Measurng Tape
• Pencil
• Drill with 1/16˝ bit for pilot holes
(optional)
Product Assemblies
TDRO6
TDRO9
A
B
D
E
ROLL-OUT TRAY DIVIDER
Installation Instructions
RN-243EFS-B-0614
Inspect all parts and read all instructions prior to beginning
assembly and installation.
1
2700 Oak Industrial Drive NE , Grand Rapids, MI 49505 USA
800.253.1561 • 616.459.3311 • www.kv.com
©2014 Knape & Vogt. All rights reserved. Knape & Vogt
®
reserves the right to change specications without notice. Made in USA.
2
3
4
step 4
step 3
step 2
C
F
step 1
B
C