Installation Guide

If you have any questions, please give us a call. Call Toll Free 1-800-456-7865
Knaack® products are protected by one or more of the following patents or trademarks: U.S. - 5076078, 1182980, 1182981, 1182982,
1182983, 1517767, 1560477, 1897535, 945736; Canada - 280058, 283281, 281398; U.K. - 2233036, 1390299; Aus - 754070, 754069;
N.Z. - 296048, 296050 other patents pending.
-NOTICE-
Any modification or unintended use of this product shall immediately void all manufacturers warranties.
Manufacturer disclaims all liability for injuries to persons or property resulting from any modification to, or
unintended use of this product.
FRONT REAR
CABINET MEMBER
SIDE VIEW
DRAWER
MEMBER
CABINET
MEMBER
FRONT VIEW
Figure 2. Caster Mounting Holes
with Whiz Nuts. Repeat this for the
remaining Casters.
Drawer Removal
3. To remove a drawer (Figure 4.),
pull the drawer out until it stops.
Notice the locking levers located
inside the track that is attached to
the drawer. Lift the left lever (A)
1/4"
Pushnut
5/16-18 x 3/4"
Carriage Bolt
Figure 3. Caster Mounting
5/16-18
Whiz Nut
while pressing down on the right
lever (B). Pull drawer clear on the
slides.
Drawer Installation
4. When right and left slides are in
place, extend fully. Next, push rear
pocket on drawer onto rear clip on
Figure 4. Upper Drawer Removal
slide and lower front pocket onto
front clip. Close the drawer com-
pletely. The mechanism will auto-
matically latch.
Drawer Slide Installation
CAUTION
Pull out only one drawer at a
time to avoid sudden tipping
of product which could cause
serious personal injury or
property damage.
5. Take one slide and insert rear clip
into rear notch, and lower front clip
into front notch (See Figure 5.).
Drawer Slide Removal
6. Reverse step 5.
Figure 5. Drawer Slide Installation
Part No. 14-4044 REV. G ECN 5285 03/13
Knaack LLC
ATTN: Warranty Claims
420 E. Terra Cotta Avenue Crystal Lake, IL 60014
www.knaack.com
If you have any questions, please call toll free at 1-800-456-7865.
©2013 Knaack LLC