Installation Guide
Data Vault
USER INSTRUCTIONS
Page 11
ENGLISH
a. Drawer Removal and Installation
1. To remove a drawer (FIG. 8), pull
the drawer out till it stops. Notice
the locking levers located inside the
track that is attached to the drawer.
Lift lever (A) while pressing down on
the right lever (B). Pull drawer clear
of the sides.
2. To replace a drawer, simply insert
the drawer slide into the cabinet slide
and close the drawer completely.
The mechanism will automatically
latch.
b. Drawer Slide Install
1. Take one slide (FIG. 9) and insert
the clips (inset) into the front and
rear notches of the drawer support
panel. Push the slide to the rear and
down. Secure the slide through the
end access hole in the slide.
2. Remove #6X1/2 screws to adjust
locations of drawers.
X. Installing Straps C
Straps have been provided to secure printer and power supply. Simply
route strap through slots and pull until snug.
CAUTION
Pull out only one drawer at a time to avoid sudden tipping of product
which could cause serious personal injury or property damage. For
optimal weight distribution of unit, install large drawers in lower
positions.
Notice: Any modication or unintended use of this product shall
immediately void all manufacture’s warranties. Manufacturer
disclaims all liability for injuries to persons or property resulting from
any modications to, or unintended use of this product.