User's Manual

The information in this document is subject to change without notice

Document Revision V0.61 2013.01.11

Pages

Street Light (HR) Installation & Operation User Guide

Once the AC power cable is connected, arrange the

internal wiring well and close the SMPS cover like the

following gure:

STEP. 22

Lamp Angle Control

This product is structured to control the lighting sur-

face by 5° in vertical direction.

Please remember the default of the product is set to 0°

when it is shipped out from the factory.

Do not disassemble the xing bolt for angle setting.

The lamp may rotate downward to damage the prod-

uct.

Remove the xing bolts in front to raise the lamp by

5°.

Push the lamp upward whiling aligning its second

and fourth bolt holes with the corresponding light

pole holes and bolt parts together for xing like the

following gure:

Put the bolts through the points where both holes

are aligned and tighten them rmly.

STEP. 23

STEP. 24