User's Manual
Table Of Contents
- User Manual
- For
- POD System
- Safety and Regualtion Warning Notice
- 1. POD System Overview
- 2. POD system Components
- 2.1 Head-end Unit
- 2.2 Remote Unit
- 3. Equipment Installation
- 4. Cable Connection
- 5. Specification
User Manual for POD Systems Revision: 0.7
© KMW USA Inc.
1818 E. Orangethrope Ave, Fullerton, CA 92831
Tel. +1 (714) 515-1100
www.kmwcomm.com
91
4.2.1.4 Ethernet cable connection for connecting with Expansion RU
If there is an expansion RU connected main RU, connect Ethernet cable with expansion RU before closing the
door for debug window and front door.
- After taking out of gasket from Ethernet cable entrance located in the middle, pass Ethernet cable through
this entrance.
- Connect Ethernet cable to EXT port (RJ 45).
- Replace gasket into Ethernet cable entrance.
- Close/fasten the door for debug window and front door by using SECURITY SCREWS (M4) and allowed
Torque: 12.0 Kgfcm.
- Connect the other side of Ethernet cable to EXT pot of expansion RU based on section 4.2.1.4.
CAUTION) The location of EXT pot in expansion RU is different from the location of EXT port in main RU. Make
sure where the location of EXT port in expansion RU is (refer to Figure 2-57) before connecting Ethernet cable to
expansion RU.