Instruction Manual

Sheet 8 of 30 Sheet 8 of 30 8/17/2008
©
CONFIDENTIAL
. Initial screen
Once application starts, initial screen (Main Window) shown in Figure 5-1 is displayed. Only one AMS
application can be run at once on a PC.
<Figure 5-1> Main Window
) Communication Mode
When click communication mode, the status of communication mode is changed. Please refer to
“Chapter 6. Functions” for setting up and using communication parameters.
Table – Communication Mode
MODE
Description
Remark
SERIAL
Uses RS-232 port to control TICU
“MODE -> SERIAL”
TCP
Uses Ethernet port (TCP) to control TICU
“MODE -> TCP”
) RS-232 (Serial) / Ethernet (TCP) TX, RX LED
In case that data is sent to ALD, TX LED will blink. In case that data is received from ALD, RX LED
will blink. If TX LED and /or RX LED are not blinking during communication, please check the cable
connection secure along with all the communication parameters.
TCP TX/RX Led
Serial TX/RX Led
Alarm Code List
ALD Control Button
Communication Mode
ALD Information
TICU Information
Antenna Information
TICU Control Button
ALD List