User Manual

INNOmovie Portable Beam Projector_Manual
10. When charging does not work
If you do not use the original adapter supplied with the INNOmovie, charging may not
be possible. Be sure to use the original adapter. If charging does not work even after
taking the above measures, contact the A/S center to check. It must be inspected toge-
ther with the adapter.
11. When the fan motor makes a lot of noise or does not spin (turns off again)
When the product is in operation, if there is a object in the inlet or outlet or block the
vent, it should be cleaned. If a foreign substance enters, it can cause noise, in this case,
it should be checked after inquiring about A/S. If the fan doesn’t operate, the product
turns off within 1 minute after power is applied.
To prevent overheating of the product is shutting down. If this occurs, you should cont-
act the A/S center and have it checked.
12. When the projector screen comes out strangely.
If the projection screen looks entirely orange, yellow, or blue, there is also black or ba-
nds on the screen. Or, if there is a line, you must contact the A/S center to check.
13. When there is no sound or noise occurs
- Check the external input or the volume of the smartphone.
- Please check the volume of the product.
- If there is a normal sound coming out of the external device (laptop) or smart phone,
contact the A/S center should be checked afterwards.
- When playing video or music using a USB , sound may not be output depending on
some audio codecs. Especially Dolby or AC3. (Check codec support)
- If sound is output from the product, but severe tearing or noise-mixed sound occurs,
contact the A/S center should be checked afterwards.
14. When disconnection continues while connecting with a smartphone in Smart View
If this symptom occurs, it is a communication error between the smartphone and the
product. Reboot the smartphone and connect again.
(Check if the mobile phone is a supported mobile phone) If it is disconnected after co-
nnecting even after rebooting the smartphone. If you are unable to solve after taking
the above measures, please contact the A/S center.
[ Storing the projector ]
When storing the projector for an extended period, please do the following:
• Make sure the temperature and humidity of the storage area are within the recommen-
ded ranges.
• Slide the adjuster feet all the way back.
• Remove the battery from the remote control.
• Put the projector in its original packaging or similar box.
INNOmovie Portable Beam Projector_Manual
Inner Page - 15