User Guide

TTE-1001 1 Installation Guide

Installation Guide

Room Temperature Transmitter

TTE-1001

Mounting

Standard:

• The base unit’s mounting slots are designed to

align with the holes in a standard 2" x 4" (51 x 102

mm) handy conduit box. Use such a box if using

conduit.

• On solid walls, normal screw and anchor systems

may be used.

Mounting 1

Connections and Wiring 2

Maintenance 2

Accessories 2

Important Notices 2

All dimensions are in inches (mm).

Hollow wall:

1. Cut a 3-3/4" x 1-3/4" rectangular opening in the

wall. (Check if unit is horizontal or vertical before

cuing.)

2. Make all necessary connections.

3. Insert an HMO-5001 Toggle Bolt Assembly

(ordered separately) through the wall and tighten.

NOTE: Care should be taken not to bend or ex the

base of the thermostat.

PAGE 1
Room Temperature Transmitter TTE-1001 Installation Guide Mounting Standard: Hollow wall: • The base unit’s mounting slots are designed to 1. Cut a 3-3/4" x 1-3/4" rectangular opening in the wall. (Check if unit is horizontal or vertical before cutting.) align with the holes in a standard 2" x 4" (51 x 102 mm) handy conduit box. Use such a box if using conduit. 2. Make all necessary connections. • On solid walls, normal screw and anchor systems 3.
PAGE 2
Connections and Wiring Accessories Refer to the wiring diagram. CEP/CSP Series ControllerActuator CEE-1100 Series Remote Thermostat Controllers HMO-5001 Toggle bolt assembly (for hollow wall installation) HMO-5002 Insulating backplate, 1-1/8" deep HMO-5007 Insulating backplate, 1-11/16" deep HMO-5022 Mounting trim plate Important Notices The material in this document is for information purposes only. The contents and the product it describes are subject to change without notice.