User Manual

TSP-5000 Series 4 Installation Guide
© 2013 KMC Controls, Inc. 882-019-01xG
KMC Controls, Inc.
19476 Industrial Drive
New Paris, IN 46553
574.831.5250
www.kmccontrols.com
[e-mail]
Important Notices
The material in this document is for information
purposes only. The contents and the product it
describes are subject to change without notice.
KMC Controls, Inc. makes no representations or
warranties with respect to this document. In no event
shall KMC Controls, Inc. be liable for any damages,
direct or incidental, arising out of or related to the
use of this document.
Maintenance
No routine maintenance is required. Each compo-
nent is designed for dependable, long-term reliabil-
ity, and performance. Careful installation will also
ensure long-term reliability and performance.
Accessories
CME-1002 Single auxiliary switch
CME-1004 Double auxiliary switch
HFO-0011 3/8" shaft adaptor
HMO-1003 Replacement non-rotation
bracket (one included)
HMO-4518 Snap-in connector for 1/2"
exiblemetalconduit
HMO-4520 Compression connector for
plenum cable
HMO-4526 Female connector for 1/2"
conduit
SSS-1002 DP(dierentialpressure)ow
sensor, one sensing point, 3-5/32"
(80 mm) length
SSS-1003 DPowsensor,twosensing
points, 5-13/32" (137 mm) length
SSS-1004 DPowsensor,threesensing
points, 7-21/32" (195 mm) length
SSS-1005 DPowsensor,foursensing
points, 9-29/32" (252 mm) length
More Information
For specications, see
the TSP-5000 Series
Data Sheet on the KMC
web site.