User Guide

Table Of Contents

AG150119E 7

(HPO-9002) Foam Gasket on a (NetSensor) Backplate

NOTE: The notch in the HPO-9002 gasket should match the location of the

notch in the STE-9000 series NetSensor case. (AppStats, on the other

hand, do not have a notch in the case.)

NOTE: Older CTE-1000/1100 series thermostats and TTE-1001 transmitters

have plastic extenders to help insulate them from the wall’s surface.

• After reducing environmental issues as much as possible, calibrate the sensor

(controller or thermostat input) for maximum accuracy within its environment.

See the relevant product calibration procedure to provide the optimal offset.

(Wait until the sensor has been operating for at least half an hour before

calibrating it.)

• See also Mounting for Optimal Temperature Sensing on page 3.

HMO-5002 Light almond (shown) backplate extender

and insulator, 1-1/8 inches deep, for CTE-

1xxx thermostats, CTE-11xx thermostats,

and TTE-1001 transmitters

HMO-5012 White, 1-1/8 inches deep

HMO-5007 Light almond (shown), 1-11/16 inches

deep

HMO-5013 White, 1-11/16 inches deep

Mounting Insulators

HPO-1161 Foam insulating gasket for KMD-116x/118x/12x1

and STE-8x01 NetSensors (mounts between the

black backplate and the electrical box)

HPO-9002 Foam insulating gasket for STE-9xx1 NetSensors